In 2023 we built an orbital shaker to degas samples for our EasyDens SG meter. It did the job, but the stepper motor was noisy, and the CNC-milled plexiglass turned out to be brittle – it cracked. So here is version 2: a DC gear motor with a speed knob, in a housing printed in glass-fibre-filled ABS.

A DC gear motor instead of a stepper
The stepper motor, its driver board and the Arduino that ran them are gone. The new shaker has a ready-made 12 V DC gear motor, about 200 rpm, driven by a simple PWM board. A knob on the front sets the speed – no microcontroller, no code. And it’s far quieter.

Printed in ABS-GF
The old housing was milled from plexiglass, and plexiglass is brittle – ours cracked for real. The new one is printed on our Bambu Lab H2S in ABS-GF, ABS reinforced with glass fibre: stiffer than plain ABS and far less brittle than plexiglass. We anneal the printed parts in an oven, stepping up to 90 °C over eight hours, to relieve the stresses from printing. Steel threaded inserts in the corners take the screws that hold the lid.
Same principle as before
Under the carbon fibre platform, three eccentrics move it in small circles without letting it turn. Magnets still hold the sample flask in place, and we still shake each sample for 12 minutes – about 15 ml at a time, so we can take a sample as often as we like.
The first version and how we built it are still in the 2023 post.